引用本文:
【打印本页】   【HTML】   【下载PDF全文】   查看/发表评论  【EndNote】   【RefMan】   【BibTex】
←前一篇|后一篇→ 过刊浏览    高级检索
本文已被:浏览 492次   下载 258 本文二维码信息
码上扫一扫!
分享到: 微信 更多
一种基于亚射流的PMIG焊电弧电压控制方法
林放1, 魏仲华2, 陈小峰2, 崔龙彬2, 薛家祥2
1.江门职业技术学院机电技术系, 江门 529000;2.华南理工大学机械与汽车工程学院, 广州 510640
摘要:
针对熔化极脉冲氩弧焊(PMIG焊)主要采用恒流控制和等速送丝的焊接方式,提出了一种基于亚射流的PMIG焊电弧电压控制方法;其控制原理是对每个脉冲周期的平均电弧电压进行检测,当平均电弧电压在亚射流区域内,则完全依靠其在亚射流区域内固有的自身调节能力进行调节,当平均电弧电压超出亚射流区域后,在其它焊接参数不变的条件下,通过改变基值时间来改变脉冲周期内的平均电流值,从而改变焊丝熔化速度,提高电弧调节能力和抗扰动能力.结果表明,采用该控制方法可以显著改善焊接电弧的动态响应特性,有效抑制电弧电压的扰动,焊缝成形均匀一致.
关键词:  熔化极脉冲氩弧焊  亚射流  电弧电压控制
DOI:
分类号:
基金项目:国家自然科学基金资助项目(50875088);广东省科技计划资助项目(201B010700001);番禺区科技攻关资助项目(2010-Z-22-1);黄埔区科技攻关资助项目(1021)
Method of pulsed-MIG welding arc voltage control based on sub-spraying transfer
LIN Fang1, WEI Zhonghua2, CHEN Xiaofeng2, CUI Longbin2, XUE Jiaxiang2
1.Department of Electromechanical Technology, Jiangmen Polytechnic, Jiangmen 529000, China;2.School of Mechanical & Automotive Engineering, South China University of Technology, Guangzhou 510640, China
Abstract:
Constant current control and constant wire feed were both used in the pulsed metal argon arc welding power source.The method of pulsed-MIG welding arc voltage control based on sub-spraying transfer was put forward.Its principle is as follows:the average arc voltage of each period of pulse was measured.If the average arc voltage was within the sub-spraying transfer range, the arc length would be adjusted only by self-adjusting of the arc.But if the average arc voltage went beyond the sub-spraying transfer range, the background current time changed so that the average current in each pulse period changed, so did the burn-off rate in the welding conditions above.It was found that the arc adjustment and anti-disturbance ability were improved.The results of the tests indicated this method obviously improved the welding dynamic characteristics and efficiently restrained disturbances.In addition, well-formed welding seams were acquired.
Key words:  pulsed metal argon arc welding  sub-spraying transfer  arc voltage control